Profile STD S14M toothed belt
Description
STD toothed belts are belts suitable for non-slip drive transmission (as in the case of chain drive), since not only the friction force, but also teeth hold the belt in position. They are made of rubber with fiberglass force-bearing thread. They can also be considered as the predecessors of HTD types that are more commonly used today. The power transmission capacity of STD toothed belts is slightly inferior to HTD types due to the profile design of their teeth. It is always possible to use STD toothed belts instead of HTD. However, an STD type toothed belt can only be replaced with an HTD type toothed belt if the tooth depth of the pulley allows it.
STD S14M toothed belts have a pitch of 14mm, a total profile height of 10.2mm and a tooth height of 5.3mm.
The width of the STD-S14M toothed belts is available in mm. When ordering, it is necessary to specify how wide the strap should be. (Any width can be selected, standard widths are: 40mm, 55mm, 85mm, 115mm, 170mm.) Price and quantity unit: 1 mm. This strap is individually cut from the sleeve made in the factory about 1 m wide when ordered. Since it is considered a custom production, we do not exchange or take it back, and we do not accept withdrawal from the customer after the start of production (sending the confirmation).
The supplied width of STD-S14M belts may differ from the nominal width. The tolerance for belts with nominal widths narrower than 40mm (regardless of length size) is +0.8mm and -1.3mm. At nominal widths of 40-55mm, up to 840mm belt length, +1.3-1.3mm. 840mm belt length from +1.5mm to -1.5mm. For belts with nominal sizes of 55-85mm, up to 1680mm length, +1.5mm and -1.5mm. For S14M belts with a nominal width of 55-85mm reaching or exceeding 1680mm, the width tolerance can be +1.5mm and -2.0mm. From 85mm nominal width to 840mm length size below +2.3mm and -2.3mm. From 840mm upwards it can be +2.3mm and -2.8mm.
For the same use, you can find belts for different power levels in the table below. Megadyne RPP and PIX XAct are normal strength. Megadyne Silver and PIX Torque Plus are triple strength. Megadyne Gold has four times the strength. Megadyne Platinum has a strength of 5.8x.
TIP! PIX TorquePlus reinforced toothed belts are priced at a very affordable price point and are of excellent quality.